• Specially machined guide works with extra long tap & extractor to make sure the job is done right
• Works to extract frozen & broken-off spark plug sleeves in '04 to present Ford Triton Engines
• Plastic Case Included

Instructions:

1. Seat the stopper cap using a long drill bit or suitable wire sized for the internal diameter of the cap. Make sure the cap is bottomed out against the electrode strap. This will prevent thread chips from entering the cylinder bore.
   
2. Place the guide into the spark plug well.
   WARNING: DO NOT USE AIR OR POWERED TOOLS FOR PLUG REMOVAL
   
3. Coat the end of the tap with general purpose grease and slowly insert the tap through the guide and carefully tap the ground
   electrode shield. Turn and tap 3 to 4 threads into the ground electrode shield. Be sure to tap slowly and back up. Tap
   frequently to break up chips and prevent cut material from coiling up and jamming inside electrode shield.
   CAUTION: DO NOT ATTEMPT TO REMOVE THE GROUND ELECTRODE SHIELD WITH THE TAP. THE TAP MAY BREAK IF ATTEMPTED.
   
4. Once the ground electrode is tapped, insert the extractor through the guide and thread into the ground electrode shield.
   Place nylon washer and jam nut onto threaded shaft.
   
5. While holding hex end of extractor with wrench, turn jam nut with another wrench to remove ground electrode shield.