The
Atlas® RJ8000 air/hydraulic rolling jack has telescoping arms that can
be extended over the runways of a four post lift. The lift pads at the
end of these arms can be positioned under the lifting points that are
located over the runways of that four post lift. This rolling jack is
equipped with expandable rail supports which adjust to fit between the
runways of many different four post above ground lifts. These supports
have a unique roller system that allows the rolling hydraulic jack to
glide easily under the entire length of the vehicle.
The
Atlas® RJ8000 rolling bridge jack comes standard with a set of peg
style truck adapters which increases the lifting height of the lift
pads. These truck adapters will allow the RJ8000 to raise most pick up
and larger trucks that will sit higher than the average passenger car.
The RJ8000 rolling hydraulic jack features two solid locking positions
that are used when the vehicle is to be suspended above the runways.
When the locking positions are engaged, the hydraulic pressure from the
lifting cylinder of the jack is eliminated. (These locks act much like a
pair of jack stands after you lift a vehicle off the ground with a
service jack).
IMPORTANT:
The Atlas® RJ8000 is designed and engineered to operate on “delivered”
air pressure of between 70-115 PSI. If you exceed 115 PSI, you may
damage your jack.
View Atlas RJ8000 Rolling Bridge Jack User Manual
View Atlas Rolling Jacks Measurement Guide